COMPANION Meridian Mail Instalační příručka stáhnout pdf (Strana 31)

Hardware installation 1-11

Installing the RSM breakout assembly

Standard 2.0 Meridian Mail Mini and Enhanced Card Option May 2000

Installation and Maintenance Guide

Installing the RSM

breakout assembly

If you are installing a new Meridian Mail system, install the

RSM breakout assembly before any other card.

To install the RSM breakout assembly, follow these steps.

You can now install or reinstall the Meridian Mail Enhanced

Processor Card and turn on the Meridian Mail system.

Step Action

1 When adding an RSM breakout assembly to an existing

system, courtesy down Meridian Mail and power it down.

See “Stopping Meridian Mail” on page 4-8.

2 Grasp the top lock latch with one hand and the bottom

latch with the other. Then unlock both latches

simultaneously, and pull the Meridian Mail Enhanced

Processor Card until it is unplugged from the back of the

cabinet. There is no need to remove it completely.

3 Remove the cable restraining bar.

4 Plug the end of the MDF cable equipped with a cubic

ferrite ring into the RSM breakout assembly.

5 Move the small switch on the RSM breakout assembly to

the “Normal” position, as indicated on the assembly.

6 Fit the RSM breakout assembly over the plastic extrusion

that holds the right end of the cable restraining bar in

place, plug it into the rightmost 25-pair connector, and

secure it in place with the screw provided.

7 Run the MDF cable down through the Meridian 1 cabinet

as shown in “The RSM breakout assembly” on

page 1-12.

8 Replace the cable restraining bar.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 261 262

Žádné komentáře

COMPANION Meridian Mail Instalační příručka Strana 31